Discover the Best Bike Oil Change Service Near You

 WHAT IS BIKE OIL CHANGE?

Changing the bike's oil is a great maintenance routine, mainly for motorcycles with a four-stroke engine. It keeps the engine oiled and reduces friction, overheating, and wear on all engine parts. Oil deteriorates with time, loses its effectiveness, and gathers particles of dirt and junk that might influence the working of the engine and shorten the life span. Changing the oil after certain intervals means that your engine will be in good condition, and protected from wear and tear.

BIKE OIL CHANGE TYPES

1. Routine Oil Change: Replace the conventional engine oil by draining and refilling with new oil.

2. Oil Filter Change: Replacement of the oil filter to ensure that only cleaned oil passes through the engine.

3. Full Synthetic Oil Change: Synthetic oil, gives good performance and increases the lifespan of the engine.

4. Semi-Synthetic Oil Change: This contains a mixture of conventional and synthetic oils; this balances cost with performance.

5. Transmission Oil Change: This would involve draining and replacing the oil in the transmission system.

 COMMON BIKE OIL CHANGE ISSUES

1. Dirty Oil: Dark, with lots of the kind that can cause potential damage to engine components.

2. Low Oil Levels: When there is not enough oil, the result could be overheating and increased friction.

3. Sludge Buildup: When old oil forms sludge that clogs up the inside of the engine and lessens efficiency.

4. Leaky Oil Seals: If the seals are damaged, oil leaks result in poor lubrication.

5. Inadequate Type of Oil: Oil that is not compatible with the engine in your bike affects the bike's performance and causes further damage.

 TYPES OF BIKE OIL CHANGE SERVICE

1. Engine Oil Change: Drain the old oil, replace the oil filter, and refill the new oil.

2. Oil Filter Inspection and Replacement: Check the oil filter and replace it to keep the oil clean.

3. Oil Level Check: Checks and fills (as needed) oil to recommended levels.

4. Oil Drain Plug Replacement: Replace the oil drain plug damaged by factory defect or improper torque to eliminate the oil leak problem.

5. Transmission Oil Service: Gearbox/transmission oil change for smooth shifting of gears where applicable.

 POST MAINTENANCE TIPS AFTER BIKE OIL CHANGE

1. Check Oil Level: Has the oil level been periodically checked and maintained at a recommended range?

2. Seek for Leaks: After changing the oil, check for any leaks in the drain plug or oil filter.

3. Warm Up the Engine: Let the bike warm up and run for a few minutes to circulate the new oil inside the engine.

4. Old Oil Disposal Correctness: Always make sure that old engine oil and filters are disposed of by environmental regulations.

5. Log the Oil Change: Make sure to note the date and the type of oil used for future reference.

6. Plan Regular Changes: Determine a schedule depending on the mileage covered by your bike or from any suggestions given by the manufacturer regarding the continuity of your bike's engine.